Under Door Draft Stopper (Black) Door Bottom Weather Strip Sweep for Bottom of Door Soundproof Windproof Blocker Cold Air Insulation Energy-Saving Gap Seal 39.37" L x 1.6" W x 0.16" Th (1 Pack)

The strong adhesive backing on the door bottom seal is waterproof and cold-resistant,and its adhesive strength increases over time.It is suitable for doors made of various materials,such as wood,metal,glass,and plastic.NOTE:1.If the floor within the door's opening and closing range is sloped or uneven,start installation from the highest point of the slope.Otherwise,the door may not open or close properly.2.Before installing the door draft stopper, ensure the door surface is clean and dry.3.If the door surface is rough and has cracks,it may not work well.4.Avoid frequent door openings and closings within 24 hours after installation.

• 【Thickened Material & Strong Adhesive】Under Door Draft Blocker Length 39.37"(1000mm),Width 1.6"(41mm),Thickness 0.16"(4mm).They are made from Environmentally Friendly TPE,Sturdy construction, resistant to warping and cracking, with a long service life.The strong adhesive backing is waterproof and cold-resistant, becoming even stronger over time.
• 【Noise Reduction & Multiple blocks】Door bottom seal features a high-density and Thickened (1.6 inch) design that effectively reduces outdoor noise,keeping the interior quiet.It also effectively prevents the entry of light, dust, and insects, helping to keep the interior dry, clean, and tidy.
• 【Save Energy & Money】Door draft stoppers effectively prevent energy loss from air conditioning and heating systems.In summer,they block cool air from escaping.while in winter,they keep warm air inside.There by improving the efficiency of cooling or heating your room.This helps reduce energy consumption and lower electricity bills.
• 【Easy Installation】Under Door Sweep for Exterior and Interior Doors,can be quickly installed on a door in a short amount of time.STEPS: 1.Wipe the door clean. 2.Cut the strip to the appropriate size based on the door's width. 3.Peel off the adhesive backing and apply it to the door. 4.Press firmly along the entire length of the bottom seal to ensure it adheres tightly to the door.
• 【Friendly Reminder】1.The floor must be level to ensure that Door Draft Stopper fits snugly against the floor, allowing the door to open and close properly without scraping the floor. 2.Before installing in winter,use a hair dryer to heat Door Draft Stopper for 5 minutes to maximize the adhesive's tackiness.For best results,let the weather stripping sit for 24 hours after installation before using it.